Zilog Z86C36 - Manual (Page 24)

Z86C36
ICEBOX
UM002202-1001 Setup and Installation
12
Complete Installation Instructions
The following procedures illustrate a complete step-by-step guide on
installing the ICEBOX.
Set Power Jumper
The Z86C36 ICEBOXes allow the user to power the ICEBOXes and
target from a variety of different sources. Before powering the ICEBOX
the user should select the power configuration.
The procedures below must be followed exactly as described.
Before beginning the procedures study Figure 3, which shows a
schematic of the J1 power jumper. Failure to follow the proce-
dures will result in total damage to the ICEBOX or target.
Choose from one of the following options when selecting the power
source:
•
Jumper pin 1 to pin 2 to power the ICE chip with the ICEBOX’s
adjustable regulator
•
Jumper pin 3 to pin 4 to power target with the ICEBOX’s adjustable
regulator
•
Jumper pin 1 to pin 2 and pin 3 to pin 4 to power both the ICE chip
and target from the ICEBOX’s adjustable regulator
•
Jumper pin 2 to pin 4 to power the ICE chip from the target
When powering the target from the ICEBOX ensure that the
target’s power supply is disconnected.
Caution:
Note: