Xtramus NuWIN V1.1 - Manual (Page 105)

100
E-mail: [email protected]
Website: www. X tramus.com
XTRAMUS TECHNOLOGIES
®
4.10.1 Frame Data Setup vs. Matrix Setup
Like Matrix Setup, Frame Data Setup (please see section 4,9,1 ) also supports packets
customization. To customize packets of a specific section in detail, Frame Data Setup
is recommended. Because Frame Data Setup is based on Run Time Generation,
packet data is varied through parameter.
Unlike Frame Data Setup, Matrix Setup employs All Users Predefined method, so
simultaneous configuration of multiple packets are possible ( up to 512 for XM-2301(G)),
and all these configured packets can be set in the loop count of Matrix Setup.
User can import many kinds of captured file, such as Sniffer ENC format, Matrix-
Defined format, and Default Excel File. For application, the data captured by
NuStreams module cards from real traffic can be exported and imported into Matrix
Setup for users to simulate and generate the same traffic.
In the demonstration below, send packets from port (0,3,1) to (0,2,1).
Open Matrix Setup window in order to start configuration. In this case, three packets of
70, 80, and 90 bytes are set up with CRC checksum (FCS) appended. Please note that
the counter is set as 9, which means there will be 9 packets sent for this demonstration.