Tempest TornadoRetrofit Kits - Manual (Page 22)

Tornado Enclosure User Manual
page 22
Remote Device Management (RDM)
RDM refers to ANSI E1.20, a control protocol in the entertainment industry used for device
configuration and monitoring, and essentially an “extension” of DMX512. The use of RDM is
optional, and uses the same RS485 cable connection as DMX512, so no additional wiring is
required. The user must ensure that any DMX splitters or other routing devices used are rated for
RDM as well as DMX use. Tempest strongly recommends working with a qualified RDM system
integrator when designing an RDM network. Go to www.tempestlighting.com for contact
information.
RDM and RDM Integration
DEC3.2’s RDM implementation allows system integrators to set up remote control and status
monitoring of all attributes and sensors, including:
 Relative Humidity
 Air Temperature
 PCB Temperature
 Lamp Current
 Elapsed Lamp Hours
 Lamp Relay Status
 Fan Relay Status
 Heater Relay Status
 DMX Status
 DMX Start Address
 DMX Personality (RDM Mode)
 Device Type
 Device Label
 Software Version
RDM is an effective and powerful tool for commissioning and monitoring an
installation, particularly in large systems. For further guidance, please
consult a qualified RDM system integrator. Tempest Lighting warrants
DEC3.2 to be compliant with the RDM standard, but is not an RDM systems integrator, and can
offer only basic guidance on RDM utilization.