Paxton Superchargers Denali - Manual (Page 55)

20-1
P/N: 4809639
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v3.0(01-03Denali/Esc(4809639v3.0))
Section 20
REFLASH COMPUTER
20. REFLASH COMPUTER
MICRO TUNER 2001-2004 VEHICLE PROGRAMMING INSTRUCTIONS
IMPORTANT! To ensure trouble-free programming of your vehicle's computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Do not attempt to program your vehicle while a battery charger is connected.
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
*** NOTE ***
For vehicles equipped with on-star, follow the instruc-
tions on the following page before starting.
A. Reconnect the battery.
B. Connect the supplied cable to the 9-pin
connector at the top of the hand-held unit.
If present use the thumbscrews to secure
the cable to the connector.
C. Connect the other end to your ALDL con-
nector located under the dash near the
steering column. Make sure this connec-
tion is seated all the way in and that it is
secure. You do not want this cable coming
out of the connector during programming.
D. Turn the ignition key to the "on" or "run"
position but do not start the vehicle.
E. To begin programming your vehicle, you
may either press the YES button or the A
button. If you press the YES button on the
hand-held unit, this will download the
Superchips performance program already
stored in the hand-held unit. If you press
"A", you can alter some predefined options
to suit your needs. These options are not
permanently stored in the hand-held unit.
When power is removed from the unit, the
changes you made will be lost.
F. You only need to press the YES button
once to start the programming cycle. The
programming process takes 1 minute and
15 seconds to complete.
***NOTE***
Do not disturb the cable, or turn the ignition off dur-
ing this time. If the programming is disrupted, the
computer will not start or run your vehicle.
G. The hand-held unit will inform you that
the programming process has completed
and to turn the ignition off and disconnect
the cable. Only at this time should the
ignition be turned off and the cable
removed.
H. Programming is now completed. Start the
vehicle to ensure proper operation.