Paxton Superchargers Denali - Manual (Page 25)

7-1
P/N: 4809639
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v3.0(01-03Denali/Esc(4809639v3.0))
Section 7
OIL FEED LINE
7. OIL FEED LINE
A. Remove the two screws holding the small
casting or oil cooler block located directly
above the oil filter.
B. Using engine oil on the threads, install
1/8” NPT to #4 90° fitting into the sup-
plied oil feed adapter.
C. Using the adapter, the appropriate supplied
gasket and the supplied longer 6mm
screws, assemble the components as
shown in Fig. 6-a.
D. Install a 1/8" NPT to #4 90° fitting into the
supercharger oil feed filter. Use a small
amount of engine oil on the pipe threads.
Pipe sealant should not be used as it can
clog the filter and damage the supercharg-
er.
E. Route the oil feed line from the super-
charger to the installed fitting. Use an adel
clamp on the side of the oil pan and tie
wraps to secure the oil feed and oil drain
lines and protect them from kinking, abra-
sion and high heat areas. (See Fig. 6-a.)
F. Drain the engine oil, install a new filter
and refill the engine with fresh oil.