Paxton Superchargers Denali - Manual (Page 29)

9-1
P/N: 4809639
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v3.0(01-03Denali/Esc(4809639v3.0))
Section 9
BRAKE BOOSTER LINE MODIFICATION
(HUMMER & '02 ESCALADE ONLY)
9. BRAKE BOOSTER LINE MODIFICATION (2002 Escalade Only and most Hummer H2)
*** NOTE ***
The purpose of Section 9 is to bend the brake boost-
er line and give it clearance from the supplied inlet
duct.
A. Locate the brake booster hard line running
from the master cylinder down to the
lower left corner of the power steering
pump. Disconnect the line at the master
cylinder.
B. With a 3/8" tubing bender, put a 30° bend
in the hard line. (See Fig. 9-a.)
C. Reconnect the line back to the master
cylinder with its new bend. (See Fig. 9-b.)
D. Bleed the system as follows (The engine
should be off):
1.
Raise the front wheels off the ground.
2. Turn the steering wheel full left.
3. Fill the reservoir to the “FULL
COLD” level. Maintain this level
thoughout the procedure.
4. Turn the steering wheel lock to lock
at least 20 times or until the bubbles
stop.
Fig. 9-a
Fig. 9-b
MODIFIED BRAKE BOOSTER HARD
LINE MUST CLEAR INLET DUCT