Paxton Superchargers Denali - Manual (Page 37)

12-1
P/N: 4809639
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v3.0(01-03Denali/Esc(4809639v3.0))
Section 12
INLET DUCT INSTALLATION
12.A ESCALADE/DENALI INLET DUCT INSTALLATION (’01-’02 Models)
A. Install the supplied 3-1/2" x 3" sleeve onto
the MAF outlet, and the 3-1/2" x 2" sleeve
on the inlet of the supercharger.
B. Reinstall the upper fan shroud with the
exception of the top two bolts.
C. Remove any plastic clips that are no longer
used to secure the radiator hose.
D. Slide the entry of the large plastic inlet
duct (See Fig. 12.A-d) into the sleeve
installed on the MAF. Lower the inlet duct
onto the top of the radiator shroud.
Reinstall the factory radiator shroud bolts
through the two supplied inlet duct
mounting tabs and into their original bolt
holes.
E. Insert the supplied 1/4-20 x 1/2" screws
through the bracket and into each side of
the inlet duct using trhe suppleds washers.
Tighten the screws. (See Fig 12.A-d.)
F. Install the supplied 180° inlet duct onto the
inlet of the supercharger after the super-
charger is installed. Orient the duct so that
you can just slide your fingers between the
duct and the master cylinder.
G. Install the supplied #52 hose clamps and 3-
1/2" x 13" long flex hose between the two
ducts just installed. (See Fig. 12.A-b.)
H. Using the supplied 3/8" hose from the 3/8"
fitting on the inlet duct to the passenger
side valve cover breather hose. Secure the
hose so that it cannot interfere with the
throttle arm or cable. (See Fig 12.A-c.)
I. Install and tighten the hose clamps on each
connection. (See Fig 12.A-d.)
Fig. 12.A-a
Fig. 12.A-b
Fig. 12.A-c
Fig. 12.A-d
FACTORY
SHROUD BOLT
SUPPLIED 1/4-20
HARDWARE
SUPPLIED DUCT
MOUNTING TABS
(LEFT & RIGHT)
SUPPLIED
3/8" HOSE
SUPPLIED 3/8"
RUBBER CAP