NEXCOM NCr-302-VHR - Manual (Page 55)

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved. 45
Chapter 2: Camera Configuration
NCr-302-VHR User Manual
Schedule ICR
Enables or disables IR cut filter control function to activate at the specified
time. You can configure the Start Time and End Time in 24-hour format.
Use Mode (During Scheduled Hours)
Selects the IR cut filter control mode to use during the scheduled time.
Use Mode (Outside of the Scheduled Hours)
Selects the IR cut filter control mode to use outside of the scheduled time.
IR LED Control
Auto Control by Light Sensor
When enabled, the camera will automatically turn the infrared LEDs on or
off based on the amount of light received by the image sensor.
Turn-on
Turns the IR LED on.
Turn-off
Turns the IR LED off.
Schedule IR
Enables or disables IR LED control function to activate at the specified time.
You can configure the Start Time and End Time in 24-hour format.
Use Mode (During Scheduled Hours)
Selects the IR LED control mode to use during the scheduled time.
Use Mode (Outside of the Scheduled Hours)
Selects the IR LED control mode to use outside of the scheduled time.
Gamma Control
Default
Activates the default gamma state.
Gamma
Adjusts the gamma manually, the range is 0.01 ~ 1.00, with 0.01 being the
lowest value.
Save
Save button to apply the configurations, click on this button once all the
settings are confirmed for the new changes to take effect.
Reset
Reset button to discard all the settings applied.