NEXCOM MPPC 2120T - Manual (Page 92)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 76
Chapter 4: BIOS Setup
MPPC 2120T/3220T User Manual
BIOS SETUP UTILITY
← → Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
IDE Configuration
ATA/IDE Configuration [Enhanced]
Configure SATA as [IDE]
u Primary IDE Master : [Not Detected]
u Secondary IDE Master : [Not Detected]
u Third IDE Master : [Not Detected]
IDE Detect Time Out (Sec) [35]
Advanced
IDE Configuration
This section is used to configure the IDE drives.
ATA/IDE Configuration
Sets the SATA device to Disabled, Compatible or Enhanced mode.
If you selected Compatible, the Legacy IDE Channels field will appear.
The options are SATA Only, SATA Pri, PATA Sec, and PATA Only.
If you selected Enhanced, the Configure SATA As field will appear. The
option displayed is IDE. This will configure the Serial ATA drives as Parallel
ATA physical storage device.
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
Options
Disabled
Compatible
Enhanced
Select the type
of device connected
to the system.
BIOS SETUP UTILITY
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Primary IDE Master
Device :Not Detected
Type
LBA/Large Mode
Block (Multi-Sector Transfer)
PIO Mode
DMA Mode
S.M.A.R.T.
32Bit Data Transfer
Advanced
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Disabled]
Primary IDE Master to Third IDE Master
When you enter the BIOS Setup Utility, the BIOS will auto detect the ex-
isting IDE devices then displays the status of the detected devices. To con-
figure an IDE drive, move the cursor to a field then press .