NEXCOM MPPC 2120T - Manual (Page 79)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 63
Chapter 3: System Setup
MPPC 2120T/3220T User Manual
Panel Mounting
1. Select a place on the panel where you will mount the Panel PC.
2. Cut out a shape on the panel that corresponds to the Panel PC’s rear
dimensions.
The thickness of the panel (e.g. steel board, plank, acrylic board, wall,
etc.) where you will mount the Panel PC must not exceed 7mm. If the
distance between the front bezel and panel mount hole is too wide, it
will not fit the panel mount kit.
MPPC 2120T
MPPC 3220T
3. Slide the Panel PC through the hole until it is properly fitted against the
panel.