KLING & FREITAG K&F TOPAS - Manual (Page 52)

User's manual System Amplifier K&F TOPAS
KLING & FREITAG GMBH © 2014 Version 3.1 Page 52 of 65
8. Technical SpecificationsTOPAS
8.1 Amplifier
Output power
(IEC: 1 kHz, 1% THD, both channels) 2 x 1100 W / 2 Ohm
2 x 1000 W / 4 Ohm
2 x 500 W / 8 Ohm
Bridge Mode 1 x 2050 W / 4 Ohm
1 x 2000 W / 8 Ohm
THD 0.02% @ 2/3 of rated power, 8 Ohm
Frequency Response 20 Hz - 20 kHz (-0,3 dB)
Gain 21 dB - 39 dB
SNR (signal noise ratio) > 102 dB
CMR (common mode rejection) > 75 dB
Mains Connector Powercon
Mains Voltage 115/230 V with softstart function
Rated Power 7 A
Ventilation 3 temperature-controlled quality fans
Optional AES input with bufferd link output
Hardware bypass if no mains voltage is
present.
8.2 Signal Processing
Digital signal processing 24 bit / 96 kHz (AD- and DA-converter)
32 bit / 96 kHz (DSP: 96 kHz sample rate,
32Bit)
Latency (analogue in / analogue out) 1.3 ms
Audio In-, Outputs 2 symmetrical inputs on XLR and Phoenix
2 Speakon NL4, Phoenix
2 symmetrical Link-Outputs (XLR)
Input impedance: 20 kOhm (symmetrical)
Nominal Input Level 18 dBu @ 21 dB
12 dBu @ 27 dB
6 dBu @ 33 dB
0 dBu @ 39 dB
Aux-input (PRIO) 1 symmetrical input on Phoenix with
switchable priority
GPI 4 freely assignable inputs with analogue
voltage levels of 0-10 V,