KLING & FREITAG K&F TOPAS - Manual (Page 33)

User's manual System Amplifier K&F TOPAS
KLING & FREITAG GMBH © 2014 Version 3.1 Page 33 of 65
6.3.2 Speaker Configuration
Menu: Audio » speakers
Under this menu item, you configure the speakers.
To make an optimal protection and equalisation of the attached speakers possible, special
speaker blocks are available from Kling & Freitag.
You choose the attached speakers the selections in the select list 'Select attached speaker'.
If a selected speaker block has special filters, these are shown under 'switchable filter'. You
can deactivate each of these filters.
Activate an LShelv filter in the audio settings when using SEQUENZA 5 and SEQUENZA 10
speakers. These filter settings depend on the number of speakers. Please refer to the relevant
chart in chapter 'LShelv = Low Shelving Filter' on page 54 for SEQUENZA speaker array
settings. LShelv = Low Shelving Filter58
Using the parameter 'Limit Reduction', you can reduce the RMS limiter threshold and the
peak level of the speakers. This allows to limit the output power to comply with noise
emission standards, or the speaker to operate at reduced power for other reasons.
When operating in the 'Load Monitorings' mode, you have to specify the number of
speakers. In the current version of the firmware, this setting does not have any function yet.