KLING & FREITAG K&F TOPAS - Manual (Page 18)

User's manual System Amplifier K&F TOPAS
KLING & FREITAG GMBH © 2014 Version 3.1 Page 18 of 65
Start your browser by selecting the device in the mDNS service or enter the IP address directly
into the browser address bar.
Please note that the access to some functions can be limited due to different access rights.
You can set the passwords for the access rights in the web interface (see page 39).
In the first password request of the TOPAS please fill in the fields:
• Username: master
• Password: master
Tip
You should change the passwords entered by the manufacturer in the web interface. (see
page 39)
Now you can use all functions of the amplifier. You will find detailed descriptions of the
individual functions in the following chapters. You can open the individual function menus
using the navigation bar of the web interface. An overview of all configuration pages is in
the following chapter.
In the web interface, there is integrated help available for some of the device's functions. You
can find it in the menu item 'Help'.
5.4 Network
5.4.1 Ethernet Ports
The TOPAS has three RJ45 Ethernet ports. Two are on the back of the device. The interfaces
are connected to one another and with the DSP unit via an internal switch. All ports have the
same priority.
The ports recognize the connected device automatically. Speeds of 10/100Mbit/s, half or full-
duplex as well as polarity recognition are supported. The use of crossover cables or adapters
is not necessary, but possible.