DekTec DTM-3200 IP-ASI Converter User Manual
Page 26
DTM-3200 – OEM Ethernet TSoIP Converter
User Manual
26
Manageable Items - Category 0x81 – IP receive
Nr
Variable
Description
Access
Type
0x0A UDP port
1..65535; UDP port number at which
the DTM-3200 listens for the incoming
TS
R/W (V)
int16
0x0B IP-to-output delay 1..9942ms; Delay (ms) from IP input to
ASI output in milliseconds
R/W (V)
int16
0x0C Multicast address When ‘Addressing method’ is 1, this is
the multicast address at which the
DTM-3200 listens for the incoming TS
R/W (V)
IP addr
0x0D #TP per IP
Number of transport packets per IP
packet
RO
int8
0x0E Status
Current operational status:
0 = Channel is enabled; no errors
detected
1 = Channel has been disabled
2 = Channel is enabled, but there is a
problem with the processing of the
received IP stream
RO
int8
0x0F Protocol
Protocol used by the incoming IP
stream:
0 = UDP
1 = RTP
RO
int8
0x10 Index
Channel index; always 1 for the
DTM-3200 (because it supports a single
channel only)
RO
int32
0x11 Output type
Identifies the type of output interface:
1 = ASI output
2 = parallel output
RO
int8
0x12 Packet size
0 = 188 bytes
1 = 204 bytes
RO
int8
0x13 Bitrate
Estimated bitrate (in bps@188) of the
incoming TS
RO
int32
0x14 PCR present
0 = No PCRs in incoming TS
1 = PCRs found in incoming TS
RO
int8
0x15 Rate-change
counter
Counter that keeps the number of
bitrate changes detected on this
channel. During normal operation this
counter should remain constant
RO
int32