3 configuration #2: converting asi to tsoip, 1 test set-up, 2 configuring the asi to tsoip conversion – DekTec DTM-3200 IP-ASI Converter User Manual
Page 12
DTM-3200 – OEM Ethernet TSoIP Converter
User Manual
12
The DTM-3200 will now receive a TSoIP stream and transmit this stream on the ASI port. The status
LED will be green to indicate successful transmission of the TS on the ASI output. If no TSoIP stream
is received, the status LED will be red.
2.3 Configuration #2: Converting ASI to TSoIP
This set-up will receive a stream on the ASI interface and transmit the stream over IP.
2.3.1 Test set-up
The equipment and tools are similar to the ones listed in §2.2.1 In this case we need an external ASI
source and a TSoIP receiver on the network.
2.3.2 Configuring the ASI to TSoIP conversion
The settings below (sequential order) set up the DTM-3200 for ASI to IP conversion. No FEC will be
generated in this example.
Category
Setting
Value
1
0x82: IP transmit
1: Enable
0 = Off
2
0x82: IP transmit
3: FEC Enable
0 = Off
3
0x82: IP transmit
6: IP Address
224.1.1.1
4
0x82: IP transmit
8: UDP Port
5678
5
0x82: IP transmit
9: #TP per IP
3 = 3 Transport Packets per IP pckt
6
0x82: IP transmit
10: Protocol
0 = UDP
7
0x82: IP transmit
13: Time to Live
100
8
0x83: ASI/par. input 1: Packet Size
0 = 188-byte MPEG-2 packets
9
0x82: IP transmit
1: Enable
1 = On