Signal source controls, Channel information, Signal source controls 4.14. channel information – Dataman 520 Series User Manual
Page 20
DATAMAN 520 series oscilloscope with rollmode
User’s Guide
Fig. 4.12.1. – Vertical shift controls
Channel A controls are located in left, channel B controls are located in the right.
- the waveform is shifted upwards by smallest possible value
- the waveform is shifted downwards by smallest possible value.
Click between slider and button to shift waveform by approx. 1 point.
The vertical shift can be set by dragging the slider as well.
4.13. Signal source controls
The signal source controls are located in the right of the main window.
Fig. 4.13.1. – Signal source controls
Channel A controls are located in the left, channel B controls are located in the right.
“1:1”, “1:10”, “1:100” or “1:1000” – probe attenuation ratio
WARNING: Selection of improper probe attenuation may result in wrong
information about voltages.
Click
to select coupling. Click
to ground input.
4.14. Channel information
The channel information are displayed in the top of the main window.
Channel A information are located in the left, channel B information in the right.
- 20 -