Dataman 520 Series - Manual (Page 14)

DATAMAN 520 series oscilloscope with rollmode
User’s Guide
4.3. Channel visibility controls
The channel visibility controls are located in the left of the main window.
Fig. 4.3.1. – Channel visibility controls
“A“ – activates/deactivates channel A waveform
“B“ – activates/deactivates channel B waveform
4.4. Display mode controls
The display mode controls are located in the left of the main window.
Fig. 4.4.1. – Display mode controls
“BF“ – activates/deactivates „Beam finder“ mode. When activated, the waveform
exceeding the vertical range is displayed as line on the appropriate side of the screen.
“Line“ – activates/deactivates mode where the sample is connected with the adjacent
one with a line.
“Rew” (Rewrite) and “Roll” control the waveform drawing mode. When “Rew” is
selected, the waveform is always drawn from the left to right side of the screen and
the old waveform is continuously cleared off. When “Roll” is selected, the waveform
is drawn always on the right edge of the screen and rolls to the left.
TIP: The “Roll” mode requires more processor time. If you display a waveform
sampled with high sampling rate, choose the “Rew” mode.
“Display” – switches on/off the oscilloscope screen
TIP: Switching off the oscilloscope screen lowers the possibility of data loss.
4.5. Data save controls
The data save controls are located in the bottom of the main window.
- 14 -