Dataman 48UXP User Manual

Page 9

Read operation (Hot Key ALT-R), you can transfer the chip

′

contents into the buffer.

4) Insert blank chip of the same type into the ZIF sockets, set the

device operation option (Hot Key F4, detail of device option,

reference to chapter 4 of this manual) then press program (Hot

Key ALT-P).

5) To speed up throughput, user can change the mode to Mass

production mode (move the mouse to device, click the left key

of mouse moving the cursor to mass production mode and click

the left key of mouse again). After entering this mode, the

Dataman-48UXP will program chips automatically after the

chip has properly inserted into the socket of the

Dataman-48UXP.

6) If the chip has configuration byte for set up the oscillator type,

watch dog, code protect, etc in the chip. User need to enable

the configuration (Hot Key ALT-G) then edit the desired set up

in to the configuration byte, then perform memory

protect/program configuration in the SW to program the

configuration byte of the chip, the configuration menu only

available if the chip has this specific function.

7) Program the configuration byte or protect the chip can also be

done in single key press or in mass production mode without

need to press the memory protect separately, to achieve this

user need to enable the memory protect in the device operation

menu first then after perform program, the programmer will

program the main buffer then program the configuration byte

or protect the chip in sequence. For chip has memory protect

function, after the code protect bit been set and perform protect,

the chip will not allow to read back again and can not verify

too.

8) For a detailed explanation of the device operation options,

please refer to Chapter 3 and 4.