Dataman 48UXP - Manual (Page 34)

menu and the contents is different from chip to chip), reference
to device configuration section. The last set up menu is statistic
configuration set up, detail of the statistic please reference to
statistic section of this manual.
Start the mass production mode
After fill and confirm all the above set up, the figure 4.2 screen
will display, inset the chip in the ZIF socket and the screen of
the ZIF socket will change color showing the chip insert into
the ZIF socket, green color indicate the pin has contact with the
ZIF socket properly.
No any error occur, the programmer will perform all the job
define by the operation option, after complete the programming
a beep will generated by PC and the good LED lamp will flash
indicate program chip successfully. Operator just remove the
chip and insert a new chip in the socket the programming
process will continuous till next error occur or the target
quantity / failure rate hit the statistic set up. No change in
color means no contact, red color shows program error when
attempt to program the chip, PC will generated two tone to
notice the operator.