Dataman 48UXP - Manual (Page 8)

Quick Start
After execution the Dataman-48UXP software, following Dataman-48UXP
screen will display:
It shows the firmware version of Dataman-48UXP, the parallel port
that connect to the Dataman-48UXP:
1)
Select the chip to be programmed first.
Use the Hot Key “ALT-C”, then type the complete part number
of the chip to be programmed; or use the mouse to select the
desired part number.
2) Load the design file into the buffer.
Use the Hot Key “ALT-L”, then specify the origin of the file
and load.
3) Alternatively, you can read a master chip into the buffer instead
of a design file.