Dataman 48UXP - Manual (Page 12)

Device-insertion and continuity checks – No mistakes!
The Dataman-48UXP performs device-insertion and continuity
checks before programming each device. It can detect poor pin
contact, upside-down device insertion, incorrect position, and pin
number mismatch. This function protects your pocketbook by
preventing expensive chip damage caused by operator mistake.
Auto-sensing and self-programming
The Dataman-48UXP has implemented patented technology to meet
mass-production requirements. When a chip insert into the ZIF
socket, the Dataman-48UXP will start to program the chip
automatically, operator just follow the LED to remove the chip and
insert the chip without need to press any key.
Project file “Save and Load”
You can save the program configuration project file that contains the
device selection, the buffer data, and all of the program setup
options. This file can be recalled at any time for future use without
having to go through the setup procedure again. This allows you to
pass your design file to the production department without mistakes.
Variable VCC with one or two-pass verification
The Dataman-48UXP allows users to select the verification
voltage after chip programming is complete, e.g., Vcc +/-5%,
V
cc
+/-10%, Vcc can range from 2V to 7.5V. Verification
ensures that the chips have been properly programmed, with no
data retention problems.
Device support summary
Over 6500 chips support and increase the chip support through
software update from www.dataman.com . Normally we add
More than 100 new chips in each quarter’s software update.