CUE cuenium2 - Manual (Page 33)

User Manual
Page 33
www.cuesystem.com
[email protected]
Wired Touch Panels cuenium 2
IP Settings
This page is used for establishing the
communication parameters for your CUEunit.
The CUEunit uses standard internet protocol (IP)
communication parameters. Certain parameters
can be reset by the user. On start up, this page
will display the CUEunit’s given Physical address
(MAC), Current IP address. Carefully note this
addressing information (and any changes you
elect to make to the IP address, subnet mask,
or default gateway). This information must be
entered into the Cue Visual Composer program
written for your specific application. For control
systems with more than one CUEunits, a unique
IP address must be given to each CUEunit.
Some control systems are “stand alone” and not
part of a larger network. For such “stand alone”
systems, the Host name is optional. However, for
control systems that are connected to a larger
network, please obtain the Host name from
the network administrator, and enter it into the
corresponding box. DHCP is not supported in this
release.
Be sure to click the Apply button for any changes
to become effective!
DNS
This page is used for setting parameters of your
CUEunit’s DNS server.
On start up, this page will display the CUEunit’s
given Current primary DNS server, Current
secondary DNS server. You can reset the primary
DNS server and secondary DNS server manually
by entering your changes into the appropriate
boxes.
DHCP is not supported in this release.
Be sure to click the Apply button for any changes
to become effective!
SMTP
This page is used for setting parameters of SMTP
server. Set a name or an address and the port of
your SMTP server.
The SMTP server and port are used by the XPL2
commands EmailSend and PresetEmailSend.
Be sure to click the Apply button for any changes
to become effective!