CUE cuenium2 - Manual (Page 23)

User Manual
Page 23
www.cuesystem.com
[email protected]
Wired Touch Panels cuenium 2
10/100 BaseT LAN incl. PoE Connector
The 10/100 BaseT LAN is a standard network connection 10/100 BaseT LAN using RJ-45 connector. There
is no auto sense, which means it does not recognize straight through cable to cross-over cable. For the
direct PC connection it is necessary to use cross-over cable; for the connection to Ethernet switch straight
through cable. The length of the Ethernet cable connecting touch panel to the network must not exceed
100 meters.
Power over Ethernet is fully compatible with
• IEEE 802.3af (PoE) standard for 7” touch panels
• IEEE 802.3at (PoE Plus) standard for 12” touch panels.
Power over Ethernet integrates data and power on the same wires. It keeps the structured cabling safe
and does not interfere with concurrent network operation.
Power over Ethernet needs compatible Ethernet switches or injectors currently available by most leading
network equipment vendors.
Connector pin out
RJ-45 Pin Signal Cat5 Cable Color
1 TX_D1+ and PoE White / Orange
2 TX_D1- and PoE Orange
3 RX_D2+ and PoE White / Green
4
PoE +/- 48 V
Blue
5 White / Blue
6 RX-D2- and PoE Green
7
PoE Common
White / Brown
8 Brown