CUE cuenium2 - Manual (Page 17)

User Manual
Page 17
www.cuesystem.com
[email protected]
Wired Touch Panels cuenium 2
Hold touch panel in the upright position and push
it into the back box so that the thorns in the back
box slide into the grooves in the metal slat of the
touch panel.
This enables you to tilt the panel, which holds in
this position, and mount cables.
If you want to place the panel in the back box,
hold it upright and push its bottom part strongly
as deep into the back box as possible.
Then push the upper part of the panel until the
two metal catches slide into the fixing tabs.
Note:
If the touch panel does not adhere to the wall
perfectly, you can adjust it as described in the
capture Adjusting the Panel on the Wall.
Step 1 Step 2
Step 3 Step 4
Built-In Models
Placing the Touch Panel into the Back Box