CUE cuenium2 - Manual (Page 14)

User Manual
Page 14
www.cuesystem.com
[email protected]
Wired Touch Panels cuenium 2
Installation into the Furniture or Plasteboard Wall
5
5
4
2
3
1
Steps are as follows
1. Cut out a hole 1 using the template delivered with back box. If you don’t have template, use
following dimensions.
Back Box CS0409 Cutout Template
45 mm
30 mm
60 mm
45 mm
30 mm
60 mm
135 mm
179 mm
7 mm
touchCUE-7-B Front Panel Outline
198 x 147 mm
touchCUE-12-B Front Panel Outline
320 x 225 mm
Back Box Cutout
7 mm
7 mm
2. Break suitable knockout 3 for comfortable stretch of cable.
3. Make sure that the rubber friction rings 8 lean against the supports 4 and supports 4 are in the right
position - left down, right up.
4. Insert the back box 2 into the cut-out 1 and take the cables through broken off knockout.
5. Fasten 2x support 4 to the wall using screws 5.
6. Adjust the metal holder 7 as described in the chapter Adjusting the Panel on the Wall.
6
7
8