CUE cuenium2 - Manual (Page 11)

User Manual
Page 11
www.cuesystem.com
[email protected]
Wired Touch Panels cuenium 2
Part Description
Microphone
The microphone is prepared for future use. The functionality depends on a firmware version.
Motion sensor
The Motion sensor resumes touch panel from Backlight Saver mode. This functionality can be enabled /
disabled using On Screen Display or Admin Web.
IR Receiver
The built-in IR sensor carries the same functionality as irCUE Receiver or irCUE Receiver 485. This means
that touch panel can receive IR signal from CUE wireless IR control panels without the need to use any
external IR receiver.
Light Sensor
The Light Sensor automatically adjusts display backlight according ambient light level. This function has
to be enabled using On Screen Display or Admin Web.
Touch-screen display
Touch-screen display with active matrix color LCD and resistive membrane touch overlay.
Speakers
The built-in stereo speakers allows to play sounds stored in the touch panels.
Multifunctional button
The multifunctional button shows On Screen Display used for touch panel setting. For more details see
chapter o
n
s
creen
d
isPlay
.
Reset Button
When pressed the reset of the unit is performed followed by operating system boot. A thin screwdriver is
needed for press of this button.
Factory Default Button
When pressed the factory default function is performed. For factory default values see chapter Factory
Default and System Default. A thin screwdriver is needed for press of this button.
IR Capture Sensor
The built-in IR sensor allows to capture IR codes directly by touch panel. For more details see chapter IR
Capture.
IR Transmitter
IT Transmitter allows to transmit IR codes directly from touch panel. Devices can be controlled directly
without controller.
Connector 10/100 BaseT LAN incl. Power over Ethernet
The 10/100 BaseT LAN is a standard network connection equipped with Power over Ethernet using RJ-45
connector. For more details see chapter Connection.