CRU Forensic UltraDock v4 - Manual (Page 5)

WiebeTech
F o r e n s i c U l t r a D o c k v 4 U s e r M a n u a l ( A 9 - 0 0 0 - 0 0 1 4 ) R E V 1 . 6 - 5 -
2.4 Connecting and Powering Forensic UltraDock
Connect the eSATA, FireWire or USB cable from your computer into the corresponding port on Forensic
UltraDock
Connect power to the Forensic UltraDock. Use either the included
AC adapter or, optionally, you can connect a 4-wire power cable
from inside a computer case. This is useful if you wish to access a
drive inside a computer without removing it first.
Your Forensic UltraDock is now ready to use! Turn on the unit by moving the power switch to the “I”
position. The red drive access indicator will light briefly after the unit is powered up, indicating that the
FireWire bridge has successfully established communication with the drive. Thereafter, it will light
whenever the drive is accessed.
2.5 Using Forensic UltraDock with WiebeTech’s v4 Combo Adapters
Combo Adapters are available from WiebeTech that can allow your
Forensic UltraDock to access all kinds of drives. Follow these three
simple steps to use a Combo Adapter with your dock:
A. Attach the dock’s 4-wire power connector to the adapter.
B. Connect the dock’s IDE ribbon cable to the adapter’s IDE pins.
C. Connect the drive to the adapter.
You are now ready to use your dock to access the drive. Combo
Adapters are available for SATA drives, notebook drives, MicroDrives,
ZIF drives, and more. See the WiebeTech website for more details (
www.wiebetech.com ).
FireWire 400 FireWire 800 USB eSATA