D-Link DES-3250TG - Manual (Page 37)

D-Link DES-3250TG Standalone Layer 2 Switch
Network Monitoring Yes Read Only
Community Strings and Trap Stations Yes Read Only
Update Firmware and Configuration Files Yes Read Only
System Utilities Yes Ping Only
Factory Reset Yes No
Reboot Switch Yes No
User Account Management
Add/Update/Delete User Accounts Yes No
View User Accounts Yes No
Table 6-1. Admin and User Privileges
After establishing a User Account with Admin-level privileges, go to the Maintenance menu and click Save Changes. Next
click Save Configuration. The switch will now save any changes to its non-volatile ram and reboot. You can logon again and
are now ready to continue configuring the Switch.
Save Changes
The DES-3250TG has two levels of memory; normal RAM and non-volatile or NV-RAM. Configuration changes are made
effective by clicking the Apply button. When this is done, the settings will be immediately applied to the switching software in
RAM, and will immediately take effect.
Some settings, though, require you to restart the switch before they will take effect. Restarting the switch erases all settings in
RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-RAM before
rebooting the switch.
To retain any configuration changes permanently, click
Save Changes
from the Maintenance menu. The following
window will appear:
Figure 6- 4. Save Configuration window
Click the Save Configuration button to save the current switch configuration in NV-RAM. The following dialog box will
confirm that the configuration has been saved:
Figure 6- 5. Save Configuration Confirmation dialog box
Click the OK button to continue.
27