CIRCUTOR DHB Series - Manual (Page 36)

36
Type of analog output 4030 tYP_A w/r 0...2
Value
0 Voltage 0...10 V
1 Current 0...20 mA
2 Current 4...20 mA
Baud rate 4031 bAUd w/r 0...3
Value
0 4800 bit/s
1 9600 bit/s
2 19200 bit/s
3 38400 bit/s
Baud rate 4032 Prot w/r 0...3
Value
0 RTU 8N2
1 RTU 8E1
2 RTU 8O1
3 RTU 8N1
Device address 4033 Addr w/r 0...247
Update display parameters 4034 sAvE w/r 0...1
Value
0 without changes
1 update
Write of standard parameters 4035 SEt w/r 0...1
Value
0 without changes
1 set standard parameters
Password for parameters 4036 SEC w/r 0...60000
Value
0 without password
1...60000 entry in parameters preceded by a
request about the password
Current time 4037 HoUr w/r 0...2359
This parameter occurs in the ggmm format, where:
gg - means hours,
mm – means minutek.
The introduction o a wrong hour will cause the set-
ting 23, however the introduction of wrong minutes
will generate the setting 59.