CIRCUTOR DHB Series - Manual (Page 22)

22
bAUd
Baud rate of the RS-485 interface
transmission.
4800 – 4800 bit/s
9600 – 9600 bit/s
19200 – 19200 bit/s
38400 – 38400 bit/s
Prot
Kind of transmission through the
RS-485 interface.
r8n2 – RTU 8N2
r8E1 – RTU 8E1
r8o1 – RTU 8O1
r8n1 – RTU 8N1
Addr Device address 1...247
SEt
Write of manufacturer settings.
Parameter values set by the manu-
facturer are presented in the table 2. The setting of the value YES causes
the saving of standard parameters in
the meter.
SEC Introduction of a new password. 0...60000
HoUr Setting of the current time.
0,00...23,59
The introduction of an erroneous time
causes at the acceptation, the setting
23, however the introduction of errone-
ous minutes will cause the setting of the
value 59.
UnIt
Selection of measured value for
which the unit is highlighted.
U – RMS voltage
I – RMS current
P – active power
q – reactive power
S – apparent power
PF – active power factor
tG – ratio of reactive power to active
power
FI – phase shift
FrEq - frequency
EPPoS – active energy input
EPnEG – active energy output
EqPoS – reactive energy input
EqnEG – reactive energy output
PAv – mean active power
UAv – 10 minutes’ mean voltage
FAv – 10 seconds’ mean frequency.
C_EnP Reset of active watt-hour meters
The choice YES causes the reset of
active watt-hour meters