CIRCUTOR DHB Series - Manual (Page 13)

13
⇒ resignation of the parameter change,
⇒ absolute exit from the programming mode.
The pressure of the button combination and holding
down them ca 3 seconds causes the reset of alarm signaling. This ope-
ration acts only when the support function is switched on.
The pressure of the button combination
causes the
erasing of all minimal values.
The pressure of the button combination
causes the
erasing of all maximal values.
The pressure and holding down the
button ca 3 seconds
causes the entry to the programming matrix. The programming matrix
is protected by the safety code.
The pressure and holding down the
button 3 seconds causes
the entry to the menu monitoring meter parameters. One must move
through the monitoring menu by means of
and buttons.
In this menu all programmable meter parameters are only accessible
for readout, excepting service parameters. The exit for the monitoring
menu is carried out by means of the
button. In the monitoring
menu, parameter symbols are displayed alternately with their values.
The service algorithm of the meter is presented on the fig. 7.
The pressure and holding down
and buttons, ca 3 se-
conds, causes the entry to the menu monitoring measured values. One
must move through the monitoring menu by means of
,
and buttons.
The pressure of the button causes the display of successive
symbol of measured value alternately with the value. The pressure of
the
button causes the display of minimal value of the currently
displayed value, however the pressure of the button causes the
display of the maximal value of the currently displayed value.
The exit from the monitoring menu is carried out by means of the
button.
In case of capacitive load when the reactive power is displayed a sym-
bol (
) showing type of load is highlighted. Individual measurements