CIRCUTOR CIReQ - Manual (Page 33)

_______________________________________________________
_________________________________________________________________________________________________________
CIR-eQ User’s Manual 33 of 36
12.- BATTERY EXCHANGE
Pre-2012 analyzers have a rechargeable battery. In case of malfunction must plug for 12
hours to charge the battery. After that must set the time of the analyzer as described in
Chapter 13 Setting the time of the analyzer.
To proceed to change the battery, disconnect the scanner from any
source of voltage and current measurement and power
Is recommended change the battery each 5 years. To change the battery (models from
2012) remove the 7 screws on the back of the analyzer and remove the back cover.
You must respect the position of the battery as shown in the adhesive as shown in the
following picture
After changing the battery of the device must be set the time and an hour. To set the
time should follow the instructions in Chapter 13. Setting the time of the analyzer
13.- SETTING THE CLOCK OF THE ANALYZER.
User must supply and connect the device to de PC, using the wire communications given
with the device. This cable has one four-pin connector (CIR-e) and at the other end is a
DB-9 (PC).
(See instruction manual to verify connections and maximum voltage of the device)