CIRCUTOR CIReQ User Manual
Page 17

_______________________________________________________
_________________________________________________________________________________________________________
CIR-eQ User’s Manual
17 of 36
* See chapter 7. Quality events as an example.
After completing the configuration of CIR-e³, click on “Generate”.
When you select “Generate”, the software automatically creates file xxxxxxxx.xst in the
root directory of the SD card (stored in the default directory). The name file is the same
as the serial number of the unit entered in the setup menu, including the unit's
configuration and installation's characteristics, as shown on the following figure. The unit
will take this configuration when starting the measurements and the data will be recorded
from the SD memory card.
If you do not generate a setup file, store it in the root directory of the memory card or
when the CIR-eQ analyzer can not find the location of the memory card before the
parameter recording process starts, it will automatically load a setup file that has default
parameters defined. The default file loaded by the analyzer is called “Default” and its
features are described on the following figure.
Serial number: The serial number
of the setup file is the device’s
serial number.
Report name: The name of the
report is “Default”.
Register period: Established as 10
minutes
Primary voltage: The transformer's
primary value is 1 (direct
measurement)
Secondary
voltage:
The
transformer's secondary value is 1
(direct measurement)
Nominal voltage (Ph-n): The
standard nominal voltage is 230
Vac
Nominal Freq.: The standard
frequency is 50 Hz.
Over voltage level: The threshold
for detecting an over voltage is 110
%.
Sag level: The threshold for detecting a sag is 90 %.
Interruption level: The threshold for detecting an interruption voltage is 10 %.
Over voltage hysteresis: The over voltage hysteresis value is 2 %.
Sag hysteresis: The sag voltage hysteresis value is 2 %
Interruption hysteresis: The interruption voltage hysteresis value is 2 %