Casella CEL CEL-440 - Manual (Page 27)

Operation Press Display Shows Comments
pressed and continues for
the duration set.
Run Durations of - - - -
(=none set), 1, 5, 10, 15, 20,
30 minutes, 1, 2, 4, 8, 12, 24
hours may be set.
When the Synchronization
Timer is used (√) together
with the Duration setting,
the run starts at exactly the
same time as the first
measurement period
starting after is
pressed and continues for
the duration set.
6. If required,
set
Duration
and Sync
Timer
to
enable
quick
edit
mode.
Use and to select a
field.
Use
and to change
the entry in the field.
Save the settings by
pressing again to
resume normal operation.
Press
to return to the
Timers menu.
7. If required
select
Delay
Timer from
Timers
menu
followed
by
The first menu allows the
seven 7 sets of run start and
stop times to be repeated
up to 999 times.
When required, use to
enable quick edit mode, use
and to change the
entry, then save the setting
by pressing again.
8. Select
second
Delay
Timer
menu
The second menu controls
seven 7 sets of run start and
stop times where the time is
shown as Day/Hour:Minute.
Different measuring times
can be set for each day of
the week with the option of
repeating them over a
period of several weeks.
When a Delay Timer is used
(√), the run starts at the
preset start time and stops
at the preset stop time.
s-06
Sync Timer X
Duration - - - -
1/2
s-31
Repeat 4 Repeat
s-07
T1 X
T2 X
T2 X
T1 X ØØ/ØØ:ØØ
ØØ/ØØ:ØØ
ØØ/ØØ:ØØ
ØØ/ØØ:ØØ
1/14
Note 7: Before V 2.0 firmware, six timed measurements only with no repeat menu.
CEL-440/480 Operators Handbook - Page 27
Select Mode & Setup