beautypg.com

Hardwire installation, Fireplace installation – Dimplex BLF50 User Manual

Page 9

background image

9

Fireplace Installation

Hardwire Installation

The fireplace is packaged with a

two prong plug installed for plug-

in convenience. hard wiring the

fireplace is also an option for any

installation.

WARNINg: Do not attempt to

wire your own new outlets or

circuits. To reduce the risk of

fire, electric shock or injury to

persons, always use a licensed

electrician.

WARNINg: Ensure that the

on/off switch is set to the off

position (refer to Operation

section) and that the circuit

on which the fireplace is to be

installed has the power cut

off at the service panel until

installation is complete.

Remove the partially

1.

reflective glass from the

fireplace:

Lay fireplace on its back.

Remove two (2) Phillips

screws from each of the two

(2) glass brackets (Figure 2).
remove glass brackets.

With one hand keeping

pressure on the partially

reflective glass, tilt the

fireplace upright and slightly

Figure 2

Partially

reflective Glass

Glass bracket

bracket screws

forward to allow the partially

reflective glass to fall out of

the inside framing.

CAUTION: Partially reflective

glass is not tempered. Do

not bump or drop the partially

reflective glass to avoid breakage

and personal injury.

remove partially reflective

glass from fireplace.

Remove six (6) Phillips

2.

screws that fasten the media

tray and two (2) screws that

fasten the front panel tabs

(Figure 3). Carefully remove

both components.
Remove one (1) Phillips

3.

screw to release the electrical

box cover in the bottom, right

corner of the fireplace (Figure