Maintenance, Operation maintenance, Partially reflective glass cleaning – Dimplex BLF50 User Manual
Page 20: Fireplace surface cleaning, Servicing

20
www.dimplex.com
Battery Replacement
To replace the battery:
slide battery cover open on
1.
the remote control (Figure
19).
Install one (1) 12-volt (A23)
2.
battery in the battery holder.
Close the battery cover
3.
Operation
Maintenance
WARNINg: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
Partially Reflective Glass
Cleaning
The partially reflective glass is
cleaned in the factory during
the assembly operation. During
shipment, installation, handling,
etc., the partially reflective glass
may collect dust particles; these
can be removed by dusting lightly
with a clean dry cloth.
To remove fingerprints or other
marks, the partially reflective
glass can be cleaned with a damp
cloth. The partially reflective glass
should be completely dried with
a lint free cloth to prevent water
spots. To prevent scratching, do
not use abrasive cleaners.
Fireplace Surface
Cleaning
use only a damp cloth to clean
painted surfaces of the fireplace.
Do not use abrasive cleaners.
Servicing
Except for installation and
cleaning described in this
manual, an authorized service
representative should perform
any other servicing.
battery must be recycled
or disposed of properly.
Check with your Local
Authority or retailer for recycling
advice in your area.