Dimplex BLF50 - Manual (Page 14)

14 www.dimplex.com
Fireplace Installation
!
NOTE: The sizing has
allowed for 1/4” (6.4mm) around
the fireplace insert for ease of
installation. This fireplace does
not require any additional venting.
Choose your method of 2.
supplying power to the unit:
Plug in (you may run the •
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
hard wire the fireplace
•
(recommended). Follow the
hard wiring instructions on
page 9.
WARNINg: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the on/off switch
is set to the Off position (refer to
operation section) and that the
circuit on which the fireplace is to
be installed has the power cut off at
the service panel until installation is
complete.
Lift fireplace and insert into 3.
opening (Figure 11).
Use bubble level (supplied) to
4.
level the fireplace within the
framing. Adjust as required.
Drive four (4) supplied
5.
mounting screws through
Figure 11
Mounting
holes
Figure 10
2 x 4 Framing