Operation, Resetting the temperature cutoff switch – Dimplex BLF50 User Manual
Page 18

18
www.dimplex.com
Operation
The manual controls for the
electric fireplace are located on
the right side of the unit and inside
the air intake slot (Figure 18).
In “
OFF ” mode, power to all
functions is cut off.
In “
MANUAL ” mode, the
fireplace's three levels of
operation are controlled by the
manual Control buttons.
C. Manual Control Buttons
The manual Control buttons
operate the fireplace levels
sequentially (from off): flames
only; to flames and low heat; to
flames and high heat.
The level is increased every time
the “
I ” button is pressed, and the
fireplace can be turned off at any
point by pressing the “
O ” button.
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the on/
off switch to off and waiting five
(5) minutes before switching the
unit back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DImPLEX
(1-888-346-7539).
Figure 18
C
B
A
A. On/Off Switch
The on/off switch supplies power
to all fireplace functions. When
the switch is in the “
I ” position,
the unit is on. When in the “
O ”
position, the fireplace is off.
B. 3-Position Switch
The 3-Position switch changes
the mode the fireplace operates
in and has three (3) positions:
“
MANUAL ”; “ OFF ”; and “
REMOTE ”.
When in “
REMOTE ” mode,
the fireplace's three levels of
operation are controlled by the
ON and OFF buttons of the
remote control.