Dimplex BLF50 - Manual (Page 15)

15
Fireplace Installation
Figure 12
Mounting
hole
the four (4) mounting holes
located in each corner of the
fireplace chassis, into wall
studs (Figure 12).
refer to Front Glass
6.
Installation section, page
16 for final installation
procedures.
Flush Mounted
Installation - 2x8 Framing
CAUTION: Two people may
be required for various steps
of this procedure.
Prepare a wall with a framed 1.
opening of 49" (124.5 cm)
wide x 18½" (47 cm) high
(Figure 13).
!
NOTE: The sizing has
allowed for 1/4” (6.4mm) around
the fireplace insert for ease of
installation. This fireplace does
not require any additional venting.
Choose your method of 2.
supplying power to the unit:
Plug in (you may run the •
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
hard wire the fireplace
•
(recommended). Follow the
hard wiring instructions on
page 9.
WARNINg: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
Figure 13
2 x 8 Framing