Statement of china-rohs compliance, Statement of china-rohs compliance –20 – Altera Cyclone III FPGA Starter Board User Manual
Page 28
2–20
Altera Corporation
Cyclone III FPGA Starter Board Reference Manual
April 2012
Statement of China-RoHS Compliance
f
You can measure the core and I/O voltage with a current meter while the
Cyclone III device is in standby mode. For more information on this
circuit, refer to the
Statement
of China-RoHS
Compliance
Table 2–18
lists hazardous substances included with the kit.
3.30
100
2.0
JP5
REG3
LT1959CS8
I/O voltage and power for most
components including HSMC
12.00
200
1.0
SW1
N/A
N/A
Input supply voltage. All other
voltages (including HSMC voltage)
are derive from this regulator.
Note to
Table 2–17
:
(1)
A 0.01 current sense resistor is added to select jumper points for FPGA core power and I/O power measurement.
Table 2–17. Board Regulators
Output
Voltage
(V)
Variance
(+/- mV)
MAX
Current
(A)
Board
Access
Point
Regulator
Board
Reference
Linear
Technologies
Part #
Where Used
Table 2–18. Table of Hazardous Substances’ Name and Concentration,
Notes (1)
,
(2)
Part Name
Lead
(Pb)
Cadmium
(Cd)
Hexavalent
Chromium
(Cr6+)
Mercury
(Hg)
Polybrominated
biphenyls (PBB)
Polybrominated
diphenyl Ethers
(PBDE)
Cyclone III
FPGA starter
board
X*
0
0
0
0
0
12-V power
supply
0
0
0
0
0
0
Type A-B
USB cable
0
0
0
0
0
0
User guide
0
0
0
0
0
0
Notes to
Table 2–18
:
(1)
0 indicates that the concentration of the hazardous substance in all homogeneous materials in the parts is below
the relevant threshold of the SJ/T11363-2006 standard.
(2)
X* indicates that the concentration of the hazardous substance of at least one of all homogeneous materials in the
parts is above the relevant threshold of the SJ/T11363-2006 standard, but it is exempted by EU RoHS.