Altera Cyclone III FPGA Starter Board - Manual (Page 18)

2–10 Altera Corporation
Cyclone III FPGA Starter Board Reference Manual April 2012
Interfaces
Table 2–8 lists the HSMC A connector board reference and manufacturing
information.
The HSMC uses the Samtec connector’s header provided on the board.
Figure 2–4 shows the outline of the Samtec header.
Figure 2–4. Samtec Connector’s Header
General User Interfaces
To allow you to fully use the I/O capabilities of the Cyclone III device, the
following user interfaces are available on the board (remaining I/Os are
connected to additional board resources):
■ Push-buttons: System and user reset, and user-defined push-buttons
■ LEDs: Board-specific and user-defined LEDs
Some of the board’s buttons and LEDs have a specific board function
while others are user-defined and are provided to control FPGA designs.
Table 2–8. HSMC A Connector Manufacturing Information
Board Reference Description Manufacturer
Manufacturer
Part Number
J1 High speed
Mezzanine card
connector Samtec ASP-12953-01
2.413
((90 POS / 30 x .7875) + .050)
.78 REF
.626 REF
.036 REF .006 REF
.245 REF
.150 REF
01
02
.285 REF
DP Bank
.571
(29 EQ Spaces @ .0197)