Altera Stratix IV GT 100G - Manual (Page 44)

6–22 Chapter 6: Board Test System
Using the Board Test System
Stratix IV GT 100G Development Kit User Guide October 2010 Altera Corporation
■ TX and RX performance bars—Show the percentage of maximum theoretical data
rate that the requested transactions are able to achieve.
■ MBps —Shows the number of megabytes of data analyzed per second for transmit
and receive.
The SFPB Tab
The SFPB tab allows you to do loopback testing on this interface using different data
patterns, PMA settings, and clock speeds using the Clock Control application.
Figure 6–11 shows the SFPB tab.
1 You must have the SFPB loopback module installed on your 100G development board
for this test to work correctly.
The following sections describe the controls on the SFPB tab.
Start
The Start control initiates the SFPB loopback test.
Figure 6–11. The SFPB Tab