Altera Stratix IV GT 100G - Manual (Page 35)

Chapter 6: Board Test System 6–13
Using the Board Test System
October 2010 Altera Corporation Stratix IV GT 100G Development Kit User Guide
The DDR3 Tab
The DDR3 tab allows you to independently test each of the DDR3 memory interfaces
on your board.
Figure 6–7 shows the DDR3 tab. Since there are four DDR3 ports on
the Stratix IV GT 100G board, the DDR3 tab has 4 radio buttons to monitor each DDR3
interface.
The following sections describe the controls on the DDR3 tab.
Port
This control directs communications to one of four DDR3 memory ports on the board.
Each interface is 32 bits wide.
Start
The Start control initiates DDR3 memory transaction performance analysis.
Stop
The Stop control terminates transaction performance analysis.
Figure 6–7. The DDR3 Tab