Altera Shift Register IP Core - Manual (Page 3)

Support Device Family
Full Stratix
Preliminary Cyclone ® V (E, GX, GT, SE, SX)
Full Cyclone IV (E and GX)
Full Cyclone III
Full Cyclone II
Full Cyclone
Preliminary Arria ® V (GX, GT, GZ, SX, ST)
Full Arria II (GX and GZ)
Full Arria GX
Full HardCopy ® IV (E and GX)
Full HardCopy III
Full HardCopy II
Full HardCopy Stratix
Full MAX ® II
Full MAX 7000
Full MAX 3000A
Resource Utilization
The LPM_SHIFTREG megafunction uses one unit of logic per bit.
The MegaWizard ® Plug-In Manager reports approximate resource utilization based on your specification
and parameters. Resource Utilization is available in the lower left corner of the MegaWizard Plug-In Manager
screen.
Customizing Megafunctions in the GUI
The MegaWizard Plug-In Manager GUI allows you to define and instantiate a custom variation of an Altera
megafunction. You can edit megafunctions at any time. Megafunctions defined in your project appear in
the Project Navigator. To edit a megafunction, double-click the megafunction file in the Project Navigator
or Block Editor to display the MegaWizard GUI. To customize a megafunction using the MegaWizard
Plug-In Manager GUI, follow these steps:
1. Launch the MegaWizard Plug-In Manager using any of the following methods:
Altera Corporation LPM_SHIFTREG Megafunction
Feedback
3 Resource Utilization
UG-033105
2013.03.05