Altera Arria V GX - Manual (Page 48)

A–4 Appendix A: Programming the Flash Memory Device
Restoring the Flash Device to the Factory Settings
Arria V GX Starter Kit November 2014 Altera Corporation
User Guide
Programming the board is now complete.
f For more information about the nios2-flash-programmer utility, refer to the Nios II
Flash Programmer User Guide .
Restoring the Flash Device to the Factory Settings
This section describes how to restore the original factory contents to the flash memory
device on the starter board. Make sure you have the Nios II EDS installed, and
perform the following instructions:
1. Set the board switches to the factory default settings described in “Factory Default
Switch Settings” on page 4–2 .
2. Launch the Quartus II Programmer to configure the FPGA with a .sof capable of
flash programming. Refer to “Configuring the FPGA Using the Quartus II
Programmer” on page 6–21 for more information.
3. Click Add File and select
dir>\kits\arriaVGX_5agxfb3hf35_start\factory_recovery\a5gx_starter_fpga_bu
p_top.sof
.
4. Turn on the Program/Configure option for the added file.
5. Click Start to download the selected configuration file to the FPGA. Configuration
is complete when the progress bar reaches 100%. The Config Done LED (D12)
illuminates indicating that the flash device is ready for programming.
6. On the Windows Start menu, click All Programs > Altera > Nios II EDS > Nios II
Command Shell .
7. In the Nios II command shell, navigate to the
dir>\kits\arriaVGX_5agxfb3hf35_start\factory_recovery directory and type the
following command to run the restore script:
./restore.sh
r
Restoring the flash memory might take several minutes. Follow any instructions
that appear in the Nios II command shell.
8. After all flash programming completes, cycle the POWER switch (SW5) off then
on.
9. Using the Quartus II Programmer, click Add File and select
dir>\kits\arriaVGX_5agxfb3hf35_start\factory_recovery\a5gx_starter_fpga_bu
p_top.sof
.
10. Turn on the Program/Configure option for the added file.
11. Click Start to download the selected configuration file to the FPGA. Configuration
is complete when the progress bar reaches 100%. The Config Done LED (D12)
illuminates indicating that the flash device is ready for programming.
12. Cycle the POWER switch (SW5) off then on to load and run the restored factory
design.
13. The restore script cannot restore the board’s MAC address automatically. In the
Nios II command shell, type the following Nios II EDS command: