Altera Arria V GX - Manual (Page 20)

4–4 Chapter 4: Starter Board Setup
Factory Default Switch Settings
Arria V GX Starter Kit November 2014 Altera Corporation
User Guide
4. Set DIP switch bank (SW4) to match Table 4–4 and Figure 4–1 .
f For more information about the FPGA board settings, refer to the Arria V GX Starter
Board Reference Manual .
3 USER2
Switch 3 has the following options:
■ When ON, a logic 0 is selected.
■ When OFF, a logic 1 is selected.
OFF
4 USER3
Switch 4 has the following options:
■ When ON, a logic 0 is selected.
■ When OFF, a logic 1 is selected.
OFF
Table 4–4. SW4 Dip Switch Settings
Switch
Board
Label
Function
Default
Position
1 CLK_SEL
Switch 1 has the following options:
■ When ON, a logic 0 is selected, SMA input clock select.
■ When OFF, a logic 1 is selected, Programmable oscillator
clock select.
OFF
2 CLK_EN
Switch 2 has the following options:
■ When ON, a logic 0 is selected, on-board oscillator
disable.
■ When OFF, a logic 1 is selected, on-board oscillator
enable.
OFF
3 FAC_LOAD
Switch 3 has the following options:
■ When OFF, a logic 1 is selected, load the factory design of
Arria V device from flash at power up.
■ When ON, a logic 0 is selected, load the user design from
flash at power up.
OFF
4 RESERVED Switch 4 has no function. OFF
Table 4–3. SW3 Dip Switch Settings (Part 2 of 2)
Switch
Board
Label
Function
Default
Position