Woodhaven 4965: Super Sled - Manual (Page 8)

OPTIONAL ACCESSORIES
The 6305R Riser Kit increases the capacity of the toggle clamps to 2-3/4" thick stock.
The 3690 Mite-R-Gage is a handy tool for setting odd angles not covered by the indexing holes in the Super Sled. The 789S
Flip Stop is available for use with the Horizontal fence.
©Copyright WOODHAVEN INC. 9/25/12
(800)344-6657 or WWW.WOODHAVEN.COM
7
USING THE SUPER SLED FOR TAPERS
Set the Fence to the desired taper or angle. This is done by lining up the cut lines on your
work with the cut edge of the Sled Base, which is also the cut line of your saw. Position the fence
against the opposite side of the work and tighten. Adjust the Stop against the end of the work.
Position the handle and toggle clamps on the Fence where desired. Tighten the toggle clamps on the work using medium
pressure. Do not over tighten! Make the cut, being sure that the work is not touching the blade before starting the cut.
9
789S Flip Stop 3690 Mite-R-Gage