Crosscut fence setup – Woodhaven 4965: Super Sled User Manual
Page 3
2
FENCE BRACKET ASSEMBLY
The vertical fence configuration is normally used for
crosscuts. Insert two 5/8" screws (MF006) thru the countersink
holes in the Fence Brackets (4965C) and start an oval nut
(5760B - flat side first) on the end of each screw. Slide the
Fence Brackets on to the T-slot in the edge of each Track Bracket
(4965D), position the narrow end of the Fence Bracket even with
the end of the Track Bracket and tighten the screws. See fig. 3
Install a washer (WS002) and a 1/8" spacer (BUSH001) on
the ratchet handles (5864). Insert the stud of the ratchet handle
thru the hole of the Track Bracket. Set each Track Bracket on
the Sled base so the wide end of the Fence Brackets are towards
each other. Insert the stud of the ratchet handle thru the slot in
the Sled Base. Place a square nut (NUT025) in the recess in the
underside of the Sled Base and screw the ratchet handle into the
nut. See fig. 3-4
3
MF006 x2
HB030
WS002
5540
5864
WS002
BUSH001
4965D
4965C
5760B x2
4
NUT025
Fence Bracket
Assembly
4965B
Sled Base
4965A
Fence
Crosscut Fence Setup:
The vertical fence configuration is normally used for crosscuts. Insert a 1" bolt (HB030) thru
the hole in each of the Fence Brackets, install a washer (WS002) and a knob (5540) on the end of each
bolt. Slide the the 32" Fence (4965A) on to the bold heads and tighten the knobs. Assemble the Flip Stop
(4519) according to the directions that come with it and attach it to the top T-slot of the Fence.
See fig. 3-4
INSTALL INBOARD CLAMPS
Assemble the two Inboard Clamps (6305IC) according to the directions that come with them and attach each to an
Outboard Clamp Bracket (6305A). Insert a washer (WS002) on the 1-1/2" screws (MP150), insert the screw thru the hole in the
Outboard Clamp Bracket, place a square nut (NUT025) in the recess in each slot in the underside of the Sled Base and tighten
the screw into the nut.
5
Clamp
Assembly
Fence Brackets
4965A
Fence
4519
Flip Stop