Woodhaven 4962: Taper Master User Manual

Page 4

Assemble the two Inboard Clamps (6305IC) according

to the directions that come with them and attach them
to the front or center T-Slot of the fence. See fig. 6.

USING THE TAPER MASTER

Be sure to observe all safety precautions when

using the table saw or band saw. The cut-off from
your work can be thrown by the table saw blade as it
falls to the table. To help prevent this, clamp a 3/4"
thick board on the opposite side of the blade.

Set the fence on the Taper Master to the desired taper or

angle. This is done by lining up the cut lines on your work with
the cut edge of the base, which is also the cut line of your saw.

Position the handle on the fence where desired.

Place the work on the base and butt it against the
three Fence Plates and the Stop. Adjust and tighten the
toggle clamps on the work using medium pressure.
Do not over tighten! See fig. 7 and cover photo.

Pull the work/jig back from the saw blade, start

the saw, then slide it forward past the saw blade.

OPTIONAL ACCESSORIES
The

6305R Riser Kit increases the capacity

to the toggle clamps to 2-3/4" thick stock.

A 48" One Track (4248) and oval nuts (5750) are

available to replace the Jig Bars on the 4962 and increase
its cutting length. This extra capacity can be handy when
used on a band saw, or where cut quality won't be an issue
from the looser fit of the One Track in a miter slot.

(800) 344-6657 or WWW.WOODHAVEN.COM