Woodhaven 4962: Taper Master User Manual
Page 3
2
2
3
4
5
INSTALL FENCE
Attach the three Fence Plates (4962A) to the 36" Ultra
Track Fence (4436). Insert the 5/8" screws (MF006) thru
the countersunk holes in the plates and start 1/4-20 oval
nuts (5760B - smooth side first) on the ends of the screws.
Two of the plates have a slot and one plate has a hole near
it's edge. The plate with the hole goes on the middle of the
fence and the plates with the slots go on either end. Slide
the plates on the fence, making sure the plate with the hole
is in the center of the fence. Position each slotted plate so
it is 10" on center from the center plate. The back edge of
the three plates should be flush with the back edge of the
Ultra Track Fence. Tighten the plate screws. See fig. 2.
Attach the fence to the base. Install one 1/8" spacer
(BUSH001) on each of the three ratchet handles (5863).
Align the slots and hole in the fence plates with the slots in
the base. Insert the stud of the ratchet handle thru the hole or
slot of the fence plate and thru the slot in the base. Place a
square nut (NUT025) in the recess in the underside of the base
and screw the ratchet handle into the nut. See fig. 3 & 4.
Attach the handle to the fence. Insert a 1" bolt (HB030)
in the T-slot shown in the fence, then a 5/8" spacer (BUSH004)
and a handle (5590) on the end of the bolt. For now, position
the handle near the end of the fence and tighten. See fig. 5.
Attach the stop to the fence. Insert four 1/4" spacers
(BUSH002) on a thumb screw (NOB125) and start an oval
nut (5760B - raised side first) on the end of the thumb screw.
Slide it on to the T-slot on the edge of the fence, position it
near the end of the fence for now and tighten. See fig. 5.
Fence plates installed 10" On center
The back edge of the three plates
should be flush with the back
edge of the Ultra Track Fence
NUT015 in
recessed slot
4962A - Slotted
4962A - Slotted
4962A - Hole
5863 & BUSH002
attaching Fence
through slots
to NUT015
5590,
BUSH004
& HB030
NOB125,
BUSH002 (4)
& 5760B